Coupled Cones
Jacked Flat Bottom Cake Cones
Marron Glacés
Communion Hosts / Sacramental Bread
Chocolate Waffle Cone with Sprinkles
Sugar Wafer Stick
Pasteurizer for Ice Cream
Cups for Ice Cream
Shoulder Pads
Wadding For Shoulder Pads
Sleeve Head Rolls
Waistband
Filters
Panel Filters
Bag Filters
Flexible Control Cable
The equipment consists of an aluminum base on which are fixed:
– a mechanical lever system for bending the detail;
– a pneumatic cylinder, controlled by a two-hand safety device, for the movement of the lever;
– a template for housing the detail;
– a totalizer for counting the cycles performed;
ECT-1 – Terminal Bending Equipment
Technical Data
The equipment takes about 2 sec. to carry out the work cycle.
– dimensions: cm. 90 x 40 x H20
– weight: 20 Kg
– pneumatic supply 5 bar
The operator inserts the part in the template seat, manually positions the support on the collar and inserts the pin in the large hole of the part.
At this point he presses the two buttons to start the work cycle; at the end of this he manually removes the machined piece and the pin inserted in it.
Notes: The data included are not binding
